Offset Axle Panhard Bracket 2" Wide - 1/2" Bolt Hole

This is our idea of the correct way to make an Offset Panhard / Trackbar bracket, it seems like 3 out of 4 need to be on the leading edge of the axle for clearance issues. The center of the heim will be 6", 7" or 8" vertically from the center of the axle tube and 3.5" forward of the center of the axle tube. They are cut to a 3" axle tube radius so they can be made to fit any tube diameter & made from 1/4" plate too and bent perfectly so you don't have to play with the grinder to make them fit! They have two drain holes built in. These are setup for a 2" ID so just about any heim will fit with minimal misalignment.