The factory 9 degree angle is retained to ensure full travel of your TRE or heim joint steering set up. Without the machined section you see, full droop would be unobtainable. Whether you choose crossover or y-link style steering these arms will work for you.
These arms come with 4 stud holes drilled and tapered to accept either stock or aftermarket knuckles. They're machined from 1018 bar stock and then tumbled to remove the rough edges. They are pre tapered for GM tie rod ends and can be easily to drilled out for heim joints. They can be used for a right hand drive situation if you add a second taper on the driver side.
3 or 4 stud kits are available separately.OFFROAD USE ONLY
